Quectel M10 At Command Set

M10 AT Commands Set
M10_ATC_V1.01 - 51 -
3.2.19 AT+CLCK Facility Lock
AT+CLCK Facility Lock
Response
+CLCK: (list of supported <fac>s)
OK
Test Command
AT+CLCK=?
Parameter
see Write Command
Response
This Command is used to lock, unlock or interrogate a ME or a network
facility <fac>. Password is normally needed to do such actions. When
querying the status of a network service (<mode>=2) the response line for
‘not active’ case (<status>=0) should be returned only if service is not active
for any <class>.
If <mode><>2 and Command is successful
OK
If <mode>=2 and Command is successful
+CLCK: <status>[,<class1>[<CR><LF>
+CLCK: <status>, class2....]]
OK
Write Command
AT+CLCK =
<fac>, <mode>
[,<passwd>
[,<class>]]
Parameters
<fac> "PS" PH-SIM (lock Phone to SIM card) (ME asks password
when other than current SIM card inserted; ME may
remember certain amount of previously used cards thus
not requiring password when they are inserted)
"SC" SIM (lock SIM card) (SIM asks password in ME
power-up and when this lock Command issued)
"AO" BAOC (Barr All Outgoing Calls) (refer GSM02.88[6]
clause 1)
"OI" BOIC (Barr Outgoing International Calls) (refer
GSM02.88[6] clause 1)
"OX" BOIC-exHC (Barr Outgoing International Calls except
to Home Country) (refer GSM02.88[6] clause 1)
"AI" BAIC (Barr All Incoming Calls) (refer GSM02.88[6]
clause 2)
"IR" BIC-Roam (Barr Incoming Calls when Roaming
outside the home country) (refer GSM02.88 [6] clause
2)
"AB" All Barring services (refer GSM02.30[19]) (applicable
only for <mode>=0)
"AG" All out Going barring services (refer GSM02.30[19])
(applicable only for <mode>=0)
"AC" All in Coming barring services (refer GSM02.30[19])
Quectel

Quectel M10 Specifications

General

Brand	Quectel
Model	M10
Category	GSM/GPRS Modules
Language	English