M10 AT Commands Set
M10_ATC_V1.01 - 14 -
AT&D SET DTR FUNCTION MODE
AT&F SET ALL CURRENT PARAMETERS TO MANUFACTURER
DEFAULTS
AT&V DISPLAY CURRENT CONFIGURATION
AT&W STORE CURRENT PARAMETER TO USER DEFINED PROFILE
AT+DR V.42BIS DATA COMPRESSION REPORTING CONTROL
AT+DS V.42BIS DATA COMPRESSION CONTROL
AT+GCAP REQUEST COMPLETE TA CAPABILITIES LIST
AT+GMI REQUEST MANUFACTURER IDENTIFICATION
AT+GMM REQUEST TA MODEL IDENTIFICATION
AT+GMR REQUEST TA REVISION INDENTIFICATION OF SOFTWARE
RELEASE
AT+GOI REQUEST GLOBAL OBJECT IDENTIFICATION
AT+GSN REQUEST TA SERIAL NUMBER IDENTIFICATION (IMEI)
AT+ICF SET TE-TA CONTROL CHARACTER FRAMING
AT+IFC SET TE-TA LOCAL DATA FLOW CONTROL
AT+ILRR SET TE-TA LOCAL DATA RATE REPORTING MODE
AT+IPR SET TE-TA FIXED LOCAL RATE
2.2 Detailed Description of AT Commands According to V.25TER
2.2.1 A/ Re-issues The Last Command Given
A/ Re-issues The Last Command Given
Response
Re-issues the previous Command
Note: It does not have to end with terminating character.
Execution
Command
A/
Parameter
Reference
V.25ter
Note
This Command does not work when the serial multiplexer is active
2.2.2 ATA Answer An Incoming Call
ATA Answer An Incoming Call
To Next Page
Loading...
