Quectel M10 At Command Set

M10 AT Commands Set
M10_ATC_V1.01 - 21 -
2.2.12 ATO Switch From Command Mode To Data Mode
ATO Switch From Command Mode To Data Mode
Response
TA resumes the connection and switches back from Command mode to data
mode.
If connection is not successfully resumed
NO CARRIER
else
TA returns to data mode from Command mode CONNECT <text> Note:
<text> only if parameter setting X>0
Execution
Command
ATO[n]
Parameter
<n> 0 switch from Command mode to data mode
Reference
V.25ter
Note
2.2.13 ATP Select Pulse Dialing
ATP Select Pulse Dialing
Response
OK
Execution
Command
ATP
Parameter
Reference
V.25ter
Note
z No effect in GSM
2.2.14 ATQ Set Result Code Presentation Mode
ATQ Set Result Code Presentation Mode
Response
This parameter setting determines whether or not the TA transmits any result
code to the TE. Information text transmitted in response is not affected by
this setting.
If <n>=0:
OK
If <n>=1:
(none)
Execution
Command
ATQ<n>
Parameter
<n>
0 TA transmits result code
1 Result codes are suppressed and not transmitted
Reference
V.25ter
Note
2.2.15 ATS0 Set Number Of Rings Before Automatically Answering The Call
ATS0 Set Number Of Rings Before Automatically Answering The Call
Read Command Response
Quectel

Quectel M10 Specifications

General

Brand	Quectel
Model	M10
Category	GSM/GPRS Modules
Language	English