M10 AT Commands Set
M10_ATC_V1.01 - 90 -
by the associated memory
<oa> GSM 03.40 TP-Originating-Address Address-Value field in
string format; BCD numbers (or GSM default alphabet
characters) are converted to characters of the currently
selected TE character set (refer Command +CSCS in
TS 07.07); type of address given by <tooa>
<pdu> In the case of SMS: GSM 04.11 SC address followed by
GSM 03.40 TPDU in hexadecimal format: ME/TA
converts each octet of TP data unit into two IRA
character long hexadecimal number (e.g. octet with
integer value 42 is presented to TE as two characters
2A (IRA 50 and 65)). In the case of CBS: GSM
03.41 TPDU in hexadecimal format.
<scts> GSM 03.40 TP-Service-Center-Time-Stamp in time-string
format (refer <dt>)
<toda> GSM 04.11 TP-Destination-Address Type-of-Address octet
in integer format (when first character of <da> is +
(IRA 43) default is 145, otherwise default is 129)
<tooa> GSM 04.11 TP-Originating-Address Type-of-Address octet
in integer format (default refer<toda>)
Reference
GSM 07.05
Note
4.2.4 AT+CMGR Read SMS Message
AT+CMGR Read SMS Message
Test Command
AT+CMGR=?
Response
OK
Parameters
<index> integer type; value in the range of location numbers supported by
the associated memory
<mode> 0 normal
1 not change status of the specified SMS record
Write Command
AT+CMGR=<in
dex>[,<mode>]
Response
TA returns SMS message with location value <index> from message storage
<mem1> to the TE. If status of the message is 'received unread', status in the
storage changes to 'received read'.
1) If text mode (+CMGF=1) and Command successful:
for SMS-DELIVER:
+CMGR:
<stat>,<oa>,[<alpha>],<scts>[,<tooa>,<fo>,<pid>,<dcs>,<sca>,<tosca>,<
length>]<CR><LF><data>
for SMS-SUBMIT:
+CMGR:
<stat>,<da>,[<alpha>][,<toda>,<fo>,<pid>,<dcs>,[<vp>],<sca>,<tosca>,
<length>]<CR><LF><data>
To Next Page
Loading...
