Quectel M10 At Command Set

M10 AT Commands Set
M10_ATC_V1.01 - 32 -
2.2.40 AT+ICF Set TE-TA Control Character Framing
AT+ICF Set TE-TA Control Character Framing
Response
+ICF: (list of supported <format>s), (list of supported <parity>s)
OK
Test Command
AT+ICF=?
Parameter
See Write Command.
Response
+ICF: <format>,<parity>
OK
Read Command
AT+ICF?
Parameter
See Write Command.
Response
This parameter setting determines the serial interface character framing
format and parity received by TA from TE.
OK
Write Command
AT+ICF=[<form
at>,[<parity>]]
Parameters
<format> 1 8 data 0 parity 2 stop
2 8 data 1 parity 1 stop
3 8 data 0 parity 1 stop
4 7 data 0 parity 2 stop
5 7 data 1 parity 1 stop
6 7 data 0 parity 1 stop
<parity> 0 odd
1 even
2 mark (1)
3 space (0)
Reference
V.25ter
Note
z The Command is applied for Command state;
z The <parity> field is ignored if the < format > field specifies no
parity.
2.2.41 AT+IFC Set TE-TA Local Data Flow Control
AT+IFC Set TE-TA Local Data Flow Control
Response
+IFC: (list of supported <dce_by_dte>s), (list of supported
<dte_by_dce>s)
OK
Test Command
AT+IFC=?
Parameter
See Write Command.
Read Command Response
Quectel

Quectel M10 Specifications

General

Brand	Quectel
Model	M10
Category	GSM/GPRS Modules
Language	English