Quectel M10 At Command Set

M10 AT Commands Set
M10_ATC_V1.01 - 24 -
<n> 1-60-255 number of seconds to wait for connection completion
Reference
V.25ter
Note
z If called party has specified a high value for ATS0=<n>, call setup
may fail.
z The correlation between ATS7 and ATS0 is important
Example: Call may fail if ATS7=30 and ATS0=20.
z ATS7 is only applicable to data call.
2.2.21 ATS8 Set Number Of Second To Wait For Comma Dial Modifier Encountered In Dial
String Of D Command
ATS8 Set Number Of Second To Wait For Comma Dial Modifier Encountered In Dial
String Of D Command
Read Command
ATS8?
Response
<n>
OK
Response
OK
Write Command
ATS8=<n>
Parameter
<n> 0 no pause when comma encountered in dial string
1-255 number of seconds to wait
Reference
V.25ter
Note
z No effect for GSM
2.2.22 ATS10 Set Disconnect Delay After Indicating The Absence Of Data Carrier
ATS10 Set Disconnect Delay After Indicating The Absence Of Data Carrier
Read Command
ATS10?
Response
<n>
OK
Response
This parameter setting determines the amount of time that the TA will
remain connected in absence of data carrier. If the data carrier is once more
detected before disconnect, the TA remains connected.
OK
Write Command
ATS10=<n>
Parameter
<n> 1-
15-254 number of tenths seconds of delay
Reference
V.25ter
Note
2.2.23 ATT Select Tone Dialing
ATT Select Tone Dialing
Execution
Command
Response
OK
Quectel

Quectel M10 Specifications

General

Brand	Quectel
Model	M10
Category	GSM/GPRS Modules
Language	English