Quectel M10

M10 AT Commands Set
M10_ATC_V1.01 - 55 -
OK
Parameters
See Write Command
Response
TA disables or enables the use of result code +CME ERROR: <err> as an
indication of an error relating to the functionality of the ME.
OK
Write Command
AT+CMEE=[<n>
]
Parameters
<n>
0 disable result code
1 enable result code and use numeric values
2 enable result code and use verbose values
Reference
GSM 07.07 [13]
Note
3.2.23 AT+COLP Connected Line Identification Presentation
AT+COLP Connected Line Identification Presentation
Response
+COLP: <n>,<m>
OK
If error is related to ME functionality:
+CME ERROR: <err>
Read Command
AT+COLP?
Parameters
See Write Command
Response
+COLP: (list of supported <n>s)
OK
Test Command
AT+COLP=?
Parameters
See Write Command
Response
TA enables or disables the presentation of the COL (Connected Line) at the
TE for a mobile originated call. It has no effect on the execution of the
supplementary service COLR in the network.
Intermediate result code is returned from TA to TE before any +CR or
V.25ter responses.
OK
Write Command
AT+COLP=[<n>
]
Parameters
<n> (parameter sets/shows the result code presentation status in
the TA):
0 disable
1 enable
<m> (parameter shows the subscriber COLP service status in the
Quectel