Quectel M10 At Command Set

M10 AT Commands Set
M10_ATC_V1.01 - 132 -
OK
ERROR
Parameters
<gid1> integer type of SIM card group identifier 1
<gid2> integer type of SIM card group identifier 2
Reference Note
If the SIM supports GID files, the GID values were retuned. Otherwise 0xff
is retuned.
6.2.29 AT+QMOSTAT Show State of Mobile Originated Call
AT+QMOSTAT Show State of Mobile Originated Call
Response
+QMOSTAT: (0,1)
OK
Test Command
AT+QMOSTAT
=?
Parameters
See Write Command.
Read Command
AT+QMOSTAT
?
Response
+QMOSTAT: <mode>
OK
Response
OK
ERROR
Write Command
AT+QMOSTAT
=[<mode>]
Parameters
<mode> 0 not show call state of mobile originated call
1 show call state of mobile originated call. After dialing call
numbers, the URC strings of MO RING will be sent if the other call side is
alerted and the URC strings of MO CONNECTED will be sent if the call is
established.
Reference Note
6.2.30 AT+QGPCLASS Change GPRS Multi Slot Class
AT+QGPCLASS Change GPRS Multi Slot Class
Read Command
AT+QGPCLASS
Response
MULTISLOT CLASS: <class>
Quectel

Quectel M10 Specifications

General

Brand	Quectel
Model	M10
Category	GSM/GPRS Modules
Language	English