Quectel M10

M10 AT Commands Set
M10_ATC_V1.01 - 118 -
Response
+ QMIC: < gainlevel(Normal_Mic) >, <gainlevel(Headset_Mic)>
OK
Read Command
AT+QMIC?
Parameters
See Write Command
Response
+QMIC: (list of supported <channel >s）, (list of supported < gainlevel
>s)
OK
Test Command
AT+QMIC=?
Parameters
See Write Command
Response :
OK
ERROR
Write Command
AT+QMIC=
<channel>,<
gainlevel>
Parameters
<channel> 0 – Normal Microphone
1 – Headset Microphone
2 – Loudspeaker Microphone
<gainlevel> int: 0 – 15
Reference Note
6.2.6 AT+QALARM Set Alarm
AT+QALARM Set Alarm
Response
+QALARM: (<state>),<time>,(<repeat>),(<power>)
OK
Test Command
AT+QALAR
M=?
Parameters
See Write Command
Response
OK
ERROR
If error is related to ME functionality:
+CMS ERROR: <err>
Write
Command
AT+QALAR
M=
<state>,<time
>,<repeat>,<p
ower>
Parameters
< state > an integer parameter which indicates whether enable or disable
alarm.
0 CLEAR ALARM
1 SET ALARM
Quectel