M10 AT Commands Set
M10_ATC_V1.01 - 71 -
<Revision Id> the version, revision level or data or other information of the
device.
Reference
EIA/TIA-578-D
Note
3.2.42 AT+VTD Tone Duration
AT+VTD Tone Duration
Response
+VTD: (list of supported <n>s)
OK
Test Command
AT+VTD=?
Parameters
see Write Command
Response
+VTD: <n>
OK
Read Command
AT+VTD?
Parameter
see Write Command
Response
This Command refers to an integer <n> that defines the length of tones
emitted as a result of the +VTS Command. This does not affect the D
Command.
OK
Write Command
AT+VTD = <n>
Parameter
<n> 1-255 duration of the tone in 1/10 seconds
Reference
GSM 07.07 [13]
Note
3.2.43 AT+VTS DTMF And Tone Generation
AT+VTS DTMF And Tone Generation
Response
+VTS: (list of supported <dtmf>s), ,(list of supported <duration>s)
OK
Test Command
AT+VTS=?
Parameters
see Write Command
To Next Page
Loading...
