Quectel M10 At Command Set

M10 AT Commands Set
M10_ATC_V1.01 - 64 -
3.2.32 AT+CR Service Reporting Control
AT+CR Service Reporting Control
Response
+CR: (list of supported <mode>s)
OK
Test Command
AT+CR=?
Parameter
see Write Command
Response
+CR: <mode>
OK
Read Command
AT+CR?
Parameters
see Write Command
Response
TA controls whether or not intermediate result code +CR: <serv> is
returned from the TA to the TE at a call set up.
OK
Parameter
<mode>
0 disable
1 enable
Write Command
AT+CR=[<mode
>]
Intermediate result code
If enabled, an intermediate result code is transmitted at the point during
connect negotiation at which the TA has determined which speed and
quality of service will be used, before any error control or data
compression reports are transmitted, and before any final result code (e.g.
CONNECT) is transmitted.
+CR:<serv>
Parameter
<serv> ASYNC asynchronous transparent
SYNC synchronous transparent
REL ASYNC asynchronous non-transparent
REL SYNC synchronous non-transparent
Reference
GSM 07.07 [13]
Note
3.2.33 AT+CRC Set Cellular Result Codes For Incoming Call Indication
AT+CRC Set Cellular Result Codes For Incoming Call Indication
Response
+CRC: (list of supported <mode>s)
OK
Test Command
AT+CRC=?
Parameters
see Write Command
Quectel

Quectel M10 Specifications

General

Brand	Quectel
Model	M10
Category	GSM/GPRS Modules
Language	English