M10 AT Commands Set
M10_ATC_V1.01 - 96 -
by the associated memory
<da> GSM 03.40 TP-Destination-Address Address-Value field in
string format; BCD numbers (or GSM default alphabet
characters) are converted to characters of the currently
selected TE character set (specified by +CSCS in TS
07.07);; type of address given by <toda>
<toda> GSM 04.11 TP-Destination-Address
Type-of-Address octet in integer format (when first
character of <da> is + (IRA 43) default is 145,
otherwise
default is 129)
<mr> GSM 03.40 TP-Message-Reference in integer format
Reference
GSM 07.05
Note
4.2.8 AT+CMGC Send SMS Command
AT+CMGC Send SMS Command
Test Command
AT+CMGC=?
Response
OK
Parameters
<fo> first octet of GSM 03.40 SMS-COMMAND (default 2) in
integer format
<ct> GSM 03.40 TP-Command-Type in integer format (default 0)
<pid> GSM 03.40 TP-Protocol-Identifier in integer format (default
0)
<mn> GSM 03.40 TP-Message-Number in integer format
<da> GSM 03.40 TP-Destination-Address Address-Value field in
string format; BCD numbers (or GSM default alphabet
characters) are converted to characters of the currently
selected TE character set (specified by +CSCS in TS
07.07); type of address given by <toda>
<toda> GSM 04.11 TP-Destination-Address
Type-of-Address octet in integer format (when first
character of <da> is + (IRA 43) default is 145,
otherwise default is 129)
129 Unknown type(IDSN format number)
145 International number type(ISDN format )
<length> integer type value indicating in PDU mode (+CMGF=0), the
length of the actual TP data unit in octets (i.e. the RP
layer SMSC address octets are not counted in the
length)
Write Command
1) If text mode
(+CMGF=1):
AT+CMGC=<fo
>[,<ct><pid>,<m
n>,<da>,<toda>]
<CR>
text is entered
<ctrl-Z/ESC>
ESC quits without
sending
2) If PDU mode
(+CMGF=0):
AT+CMGC=<len
gth><CR>
PDU is given
<ctrl-Z/ESC>
Response
TA transmits SMS Command message from a TE to the network
(SMS-COMMAND). Message reference value <mr> is returned to the TE
To Next Page
Loading...
Need help?
General
