Quectel M10 At Command Set

M10 AT Commands Set
M10_ATC_V1.01 - 68 -
Test Command
AT+CRSM=?
Response
OK
Write Command
AT+CRSM=<Co
mmand>[,<fileId
>[,<P1>,<P2>,<P
3>[,<data>]]]
Response
+CRSM: <sw1>, <sw2> [,<response>]
OK / ERROR / +CME ERROR: <err>
Parameters
<Command> 176 READ BINARY
178 READ RECORD
192 GET RESPONSE
214 UPDATE BINARY
220 UPDATE RECORD
242 STATUS
all other values are reserved; refer GSM 11.11.
<fileId> integer type; this is the identifier for an elementary data file on
SIM. Mandatory for every Command except STATUS
<P1>,<P2>,<P3> integer type, range 0 - 255
parameters to be passed on by the ME to the SIM; refer GSM 11.11.
<data> information which shall be written to the SIM (hex-
decimal character format)
<sw1>, <sw2> integer type, range 0 - 255
status information from the SIM about the execution
of the actual Command. These parameters are delivered to the TE in both
cases, on successful or failed execution of the Command; refer GSM
11.11.
<response> response of a successful completion of the Command
previously issued (hexadecimal character format)
Reference
GSM 07.07
GSM 11.11
Note
3.2.37 AT+CSQ Signal Quality Report
AT+CSQ Signal Quality Report
Test Command
AT+CSQ=?
Response
+CSQ: (list of supported <rssi>s),(list of supported <ber>s)
OK
Execution
Command
AT+CSQ
Response
+CSQ: <rssi>,<ber>
OK
+CME ERROR: <err>
Execution Command returns received signal strength indication <rssi>
and
Quectel

Quectel M10 Specifications

General

Brand	Quectel
Model	M10
Category	GSM/GPRS Modules
Language	English