Quectel M10

M10 AT Commands Set
M10_ATC_V1.01 - 155 -
Write Command
AT+QIMUX=<m
ode>
Response
OK
ERROR
Parameters
<mode>
0 NOT support to establish multiple TCPIP connection at the
same time.
1 support to establish multiple TCPIP connection at the same
time.
Reference Note
7.2.25 AT+QISHOWLA Set Whether Display local IP Address When Receive Data
AT+QISHOWLA Set Whether Display local IP Address When Receive Data
Test Command
AT+QISHOWL
A=?
Response
+QISHOWLA: (list of supported <mode>s)
OK
Parameter
See Write Command
Read Command
AT+QISHOWL
A?
Response
+QISHOWLA: <mode>
OK
Parameter
See Write Command
Write Command
AT+QISHOWL
A=<mode>
Response
OK
ERROR
Parameter
<mode> a numeric parameter which indicates whether show the
prompt of where to receive the data received before or not
before received data.
0 do not show the prompt
1 show the prompt, the format is as follows: TO:<IP
ADDRESS>
Note:
1 the default mode is not to show the prompt.
Reference Note
Quectel