Quectel M10

M10 AT Commands Set
M10_ATC_V1.01 - 134 -
6.2.32 AT+QAUDLOOP Audio Channel Loopback Test
AT+QAUDLOOP Audio Channel Loopback Test
Test Command
AT+QAUDLOO
P=?
Response
+QAUDLOOP: (0-1), (0-2)
OK
Response
OK
ERROR
Write Command
AT+QAUDLOO
P:=<state>[,<typ
e>]
Parameters
<state> 0 test is off
1 test is on
<type> 0 Normal audio channel
1 Headset audio channel
2 Loudspeaker audio channel
Reference Note
6.2.33 AT+QSMSCODE Configure SMS Code Mode
AT+QSMSCODE Configure SMS Code Mode
Test Command
AT+QSMSCOD
E=?
Response
+QSMSCODE:(0,1)
OK
Response
+QSMSCODE:<mode>
OK
Read Command
AT+QSMSCOD
E?
Parameter
see Write Command
Response
OK
ERROR
Write Command
AT+QSMSCOD
E=
<mode>
Parameter
<mode> 0 code mode according with NOKIA
1 code mode according with SIEMENS
Reference
Note
Default value is 0.
Quectel