Quectel M10

M10 AT Commands Set
M10_ATC_V1.01 - 28 -
2.2.31 AT&W Store Current Parameter To User Defined Profile
AT&W Store Current Parameter To User Defined Profile
Response
TA stores the current parameter setting in the user defined profile.
OK
Execution
Command
AT&W[<n>]
Parameter
<n>
0 profile number to store to
Reference
V.25ter
Note
z The user defined profile is stored in non volatile memory.
2.2.32 AT+DR V.42bis Data Compression Reporting Control
AT+DR V.42bis Data Compression Reporting Control
Response
+DR: (list of supported <value>s)
OK
Test Command
AT+DR=?
Parameter
See Write Command.
Response
+DR: <value>
OK
Read Command
AT+DR?
Parameter
See Write Command.
Response
This parameter setting determines whether or not intermediate result code of
the current data compressing is reported by TA to TE after a connection
establishment.
OK
Write Command
AT+DR=[<value
>]
Parameter
<value>
0 reporting disabled
Reference
V.25ter
Note
2.2.33 AT+DS V.42bis Data Compression Control
AT+DS V.42bis Data Compression Control
Test Command
AT+DS=?
Response
+DS: (list of supported <p0>s), (list of supported <n>s), (list of supported
<p1>s), (list of supported <p2>s)
Quectel