M10 AT Commands Set
M10_ATC_V1.01 - 56 -
network):
0 COLP not provisioned
1 COLP provisioned
2 unknown (e.g. no network, etc.)
Intermediate result code
When enabled (and called subscriber allows), an intermediate result code is
returned before any +CR or V.25ter responses:
+COLP: <number>,<type>[,<subaddr>,<satype> [,<alpha>]]
Parameters
<number> string type phone number of format specified by
<type>
<type> type of address octet in integer format;
129 Unknown type(IDSN format number)
145 International number type(ISDN format )
<subaddr> string type sub address of format specified by <satype>
<satype> type of sub address octet in integer format (refer GSM
04.08 [8] sub clause 10.5.4.8)
<alpha> optional string type alphanumeric representation of
<number> corresponding to the entry found in phone
book
Reference Note
3.2.24 AT+COPS Operator Selection
AT+COPS Operator Selection
Response
TA returns a list of quadruplets, each representing an operator present in
the network. Any of the formats may be unavailable and should then be an
empty field. The list of operators shall be in order: home network,
networks referenced in SIM, and other networks.
+COPS: (list of supported<stat>, long alphanumeric <oper>, short
alphanumeric <oper>, numeric <oper>)s [,,(list of supported
<mode>s),(list of supported <format>s)]
OK
If error is related to ME functionality:
+CME ERROR: <err>
Test Command
AT+COPS=?
Parameters
see Write Command
Read Command
AT+COPS?
Response
TA returns the current mode and the currently selected operator. If no
operator is selected, <format> and <oper> are omitted.
+COPS: <mode>[, <format>[, <oper>]]
OK