Quectel M10 At Command Set

M10 AT Commands Set
M10_ATC_V1.01 - 108 -
requested. The allocated address may be read using the
+CGPADDR Command.
<d_comp> a numeric parameter that controls PDP data compression
0 – off (default if value is omitted)
Other values are reserved
<h_comp> a numeric parameter that controls PDP data compression
0 – off (default if value is omitted)
Other values are reserved
Reference
GSM07.07
Note
5.2.3 AT+CGQMIN Quality Of Service Profile (Minimum Acceptable)
AT+CGQMIN Quality Of Service Profile (Minimum Acceptable)
Test Command
AT+CGQMIN=?
Response
+CGQMIN: <PDP_type>,(list of supported <precedence>s),(list of
supported <delay>s),(list of supported <reliability>s),<list of supported
<peak>s),(list of supported <mean>s)
OK
Parameters
See Write Command
Read Command
AT+CGQMIN?
Response
+CGQMIN: <cid>,<precedence>,<delay>,<reliability>,<peak>,<mean>
<CR><LF>+CGQMIN:
<cid>,<precedence>,<delay>,<reliability>,<peak>,<mean>
…
OK
Parameters
See Write Command
Write Command
AT+CGQMIN=<
cid>[,<precedenc
e>[,<delay>[,<rel
iability>[,<peak>
[,<mean>]]]]]
Response
OK
If error is related to ME functionality:
+CME ERROR: <err>
Parameters
<cid> a numeric parameter which specifies a particular PDP context
definition (see +CGDCONT Command)
The following parameter are defined in GSM 03.60
<precedence> a numeric parameter which specifies the precedence class
<delay> a numeric parameter which specifies the delay class
<reliability> a numeric parameter which specifies the reliability class
<peak> a numeric parameter which specifies the peak throughput
class
<mean> a numeric parameter which specifies the mean throughput
Quectel

Quectel M10 Specifications

General

Brand	Quectel
Model	M10
Category	GSM/GPRS Modules
Language	English