Quectel M10 At Command Set

M10 AT Commands Set
M10_ATC_V1.01 - 20 -
1 low speaker volume
2 medium speaker volume
3 high speaker volume
Reference
V.25ter
Note
z The two commands ATL and ATM are implemented only for V.25
compatibility reasons and have no effect.
2.2.10 ATM Set Monitor Speaker Mode
ATM Set Monitor Speaker Mode
Response
OK
Execution
Command
ATM<value>
Parameter
<value> 0 speaker is always off
1 speaker on until TA inform TE that carrier has been
detected
2 speaker is always on when TA is off-hook
Reference
V.25ter
Note
z The two commands ATL and ATM are implemented only for V.25
compatibility reasons and have no effect.
2.2.11 +++ Switch From Data Mode Or PPP Online Mode To Command Mode
+++ Switch From Data Mode Or PPP Online Mode To Command Mode
Response
This Command is only available during a CSD call or a GPRS connection
or a transparent TCPIP connection.The +++ character sequence causes the
TA to cancel the data flow over the AT interface and switch to Command
mode. This allows you to enter AT Command while maintaining the data
connection to the remote server or, accordingly, the GPRS connection.
OK
To prevent the +++ escape sequence from being misinterpreted as data, it
should comply to following sequence:
1. No characters entered for T1 time (0.5 seconds)
2. “+++” characters entered with no characters in between
3. No characters entered for T1 timer (0.5 seconds)
4. Switch to command mode, otherwise go to step 1.
Execution
Command
+++
Parameter
Reference
V.25ter
Note
z To return from Command mode back to data or PPP online mode:
Enter ATO.
Quectel

Quectel M10 Specifications

General

Brand	Quectel
Model	M10
Category	GSM/GPRS Modules
Language	English