Quectel M10 At Command Set

M10 AT Commands Set
M10_ATC_V1.01 - 97 -
on successful message delivery. Value can be used to identify message upon
unsolicited delivery status report result code.
1) If text mode(+CMGF=1) and sending successful:
+CMGC: <mr> [,<scts>]
OK
2) If PDU mode(+CMGF=0) and sending successful:
+CMGC: <mr> [,<ackpdu>]
OK
3)If error is related to ME functionality:
+CMS ERROR: <err>
Parameters
<mr> GSM 03.40 TP-Message-Reference in integer format
Reference
GSM 07.05
Note
4.2.9 AT+CNMI New SMS Message Indications
AT+CNMI New SMS Message Indications
Response
+CNMI: (list of supported <mode>s),(list of supported <mt>s),(list of
supported <bm>s),(list of supported <ds>s),(list of supported <bfr>s)
OK
Test Command
AT+CNMI=?
Parameters
see Write Command
Response
+CNMI: <mode>,<mt>,<bm>,<ds>,<bfr>
OK
Read Command
AT+CNMI?
Parameters
see Write Command
Write Command
AT+CNMI=[<m
ode>[,<mt>[,<b
m>
[,<ds>[,<bfr>]]]]]
Response
TA selects the procedure for how the receiving of new messages from the
network is indicated to the TE when TE is active, e.g. DTR signal is ON. If
TE is inactive (e.g. DTR signal is OFF), message receiving should be done
as specified in GSM 03.38.
OK
If error is related to ME functionality:
ERROR
Quectel

Quectel M10 Specifications

General

Brand	Quectel
Model	M10
Category	GSM/GPRS Modules
Language	English