M10 AT Commands Set
M10_ATC_V1.01 - 98 -
Parameters
<mode> 0 Buffer unsolicited result codes in the TA. If TA result
code buffer is full, indications can be buffered in some
other place or the oldest indications may be discarded
and replaced with the new received indications.
1 Discard indication and reject new received message
unsolicited result codes when TA-TE link is reserved
(e.g. in on-line data mode). Otherwise forward them
directly to the TE.
2 Buffer unsolicited result codes in the TA when TA-TE
link is reserved (e.g. in on-line data mode) and flush
them to the TE after reservation. Otherwise forward
them directly to the TE.
3 Forward unsolicited result codes directly to the TE.
TA-TE link specific inband technique used to embed
result codes and data when TA is in on-line data mode.
<mt> (the rules for storing received SMs depend on its data coding
scheme (refer GSM 03.38 [2]), preferred memory
storage (+CPMS) setting and this value):
0 No SMS-DELIVER indications are routed to the TE.
1 If SMS-DELIVER is stored into ME/TA, indication of
the memory location is routed to the TE using
unsolicited result code: +CMTI: <mem>,<index>
2 SMS-DELIVERs (except class 2) are routed directly to
the TE using unsolicited result code: +CMT:
[<alpha>],<lengt
h><CR><LF><pdu> (P
DU mode
enabled) or +CMT: <oa>, [<alpha>],<scts>
[,<tooa>,<fo>,<pid>,<dcs>,<sca>,<tosca>,<length
>]<CR><LF><data> (text mode enabled; about
parameters in italics, refer Command Show Text Mode
Parameters +CSDH). Class 2 messages result in
indication as defined in <mt>=1.
3 Class 3 SMS-DELIVERs are routed directly to TE
using unsolicited result codes defined in <mt>=2.
Messages of other classes result in indication as
defined in <mt>=1.
<bm> (the rules for storing received CBMs depend on its data
coding scheme (refer GSM 03.38 [2]), the setting of
Select CBM Types (+CSCB) and this value):
0 No CBM indications are routed to the TE.
2 New CBMs are routed directly to the TE using
unsolicited result code: +CBM:
<length><CR><LF><pdu> (PDU mode enabled) or
To Next Page
Loading...
Need help?
General
