Quectel M10 At Command Set

M10 AT Commands Set
M10_ATC_V1.01 - 53 -
see Write Command
Response
TA enables or disables the presentation of the CLI at the TE. It has no effect
on the execution of the supplementary service CLIP in the network.
OK
If error is related to ME functionality:
+CME ERROR: <err>
Parameters
<n> 0 suppress unsolicited result codes
1 display unsolicited result codes
<m> 0 CLIP not provisioned
1 CLIP provisioned
2 unknown
Write Command
AT+CLIP=[<n>]
Unsolicited result code
When the presentation of the CLI at the TE is enabled (and calling
subscriber allows), an unsolicited result code is returned after every RING
(or +CRING: <type>) at a mobile terminating call.
+CLIP: <number>, <type>,””,,<alphaId>,<CLI validity>
Parameters
<number> string type phone number of calling address in format
specified by <type>
<type> type of address octet in integer format;
129 Unknown type(IDSN format number)
145 International number type(ISDN format )
<alphaId> string type alphanumeric representation of <number>
corresponding to the entry found in phone book
<CLI validity> 0 CLI valid
1 CLI has been withheld by the originator
2 CLI is not available due to interworking problems or
limitations of originating network
Reference Note
3.2.21 AT+CLIR Calling Line Identification Restriction
AT+CLIR Calling Line Identification Restriction
Read Command
AT+CLIR?
Response
+CLIR: <n>, <m>
OK
If error is related to ME functionality:
+CME ERROR: <err>
Quectel

Quectel M10 Specifications

General

Brand	Quectel
Model	M10
Category	GSM/GPRS Modules
Language	English