Quectel M10

M10 AT Commands Set
M10_ATC_V1.01 - 29 -
OK
Parameter
See Write Command.
Response
+DS: <p0>,<n>,<p1>,<p2>
OK
Read Command
AT+DS?
Parameter
See Write Command.
Response
This parameter setting determines the possible data compression mode by
TA at the compression negotiation with the remote TA after a call set up.
OK
Write Command
AT+DS=[<p0>,[<
n>,[<p1>,[<p2>]]
]]
Parameters
<p0> 0 NONE
<n>
0 allow negotiation of p0 down
1 do not allow negotiation of p0 - disconnect on difference
<p1>
512-4096 dictionary size
<p2> 6-250 maximum string size (default 6)
Reference
V.25ter
Note
z This Command is only for data call;
z GSM transmits the data transparent. The remote TA may support this
compression;
z This Command must be used in conjunction with Command AT+CRLP
to enable compression (+CRLP=X,X,X,X,1,X).
2.2.34 AT+GCAP Request Complete TA Capabilities List
AT+GCAP Request Complete TA Capabilities List
Response
OK
Test Command
AT+GCAP=?
Parameter
Response
TA reports a list of additional capabilities.
+GCAP: <name>s
OK
Execution
Command
AT+GCAP
Parameters
<name> +CGSM GSM function is supported
+FCLASS FAX function is supported
Reference
V.25ter
Note
Quectel