Quectel M10

M10 AT Commands Set
M10_ATC_V1.01 - 109 -
class
Reference
GSM07.07
Note
5.2.4 AT+CGQREQ Quality Of Service Profile (Requested)
AT+CGQREQ Quality Of Service Profile (Requested)
Test Command
AT+CGQREQ=?
Response
+CGQREQ: <PDP_type>,(list of supported <precedence>s),(list of
supported <delay>s),(list of supported <reliability>s),<list of supported
<peak>s),(list of supported <mean>s)
OK
Parameters
See Write Command
Read Command
AT+CGQREQ?
Response
+CGQREQ: <cid>,<precedence>,<delay>,>reliability>,<peak>,<mean>
<CR><LF>+CGQMIN:
<cid>,<precedence>,<delay>,<reliability>,<peak >,<mean>
…
OK
Parameters
See Write Command
Write Command
AT+CGQREQ=
<cid>[,<precede
nce>[,<delay>[,<
reliability>[,<pea
k>[,<mean>]]]]]
Response
OK
If error is related to ME functionality:
+CME ERROR: <err>
Parameters
<cid> a numeric parameter which specifies a particular PDP context
definition (see +CGDCONT Command)
The following parameter are defined in GSM 03.60
<precedence> a numeric parameter which specifies the precedence class
<delay> a numeric parameter which specifies the delay class
<reliability> a numeric parameter which specifies the reliability class
<peak> a numeric parameter which specifies the peak throughput
class
<mean> a numeric parameter which specifies the mean throughput
class
Reference
GSM07.07
Note
5.2.5 AT+CGACT PDP Context Activate Or Deactivate
AT+CGACT PDP Context Activate Or Deactivate
Quectel