Quectel M10

M10 AT Commands Set
M10_ATC_V1.01 - 110 -
Test Command
AT+CGACT=?
Response
+CGACT: (list of supported <state>s)
OK
Parameter
See Write Command
Read Command
AT+CGACT?
Response
+CGACT: <cid>,<state>[<CR><LF>+CGACT:<cid><state>…]
OK
Write Command
AT+CGACT=<st
ate>,<cid>
Response
OK
NO CARRIER
If error is related to ME functionality:
+CME ERROR: <err>
Parameters
<state> indicates the state of PDP context activation
0 – deactivated
1 – activated
Other values are reserved and will result in an ERROR
response to the Write Command.
<cid> a numeric parameter which specifies a particular PDP
context definition (see +CGDCONT Command)
Reference
GSM07.07
Note
If context is deactivated successfully, NO CARRIER is returned
5.2.6 AT+CGDATA Enter Data State
AT+CGDATA Enter Data State
Test Command
AT+CGDATA=?
Response
+CGDATA: list of supported <L2P>s
OK
Parameter
See Write Command
Write Command
AT+CGDATA=<
L2P>[,<cid>[,<ci
d>[,…]]]
Response
OK
NO CARRIER
If error is related to ME functionality:
+CME ERROR: <err>
Parameters
<L2P> a string parameter that indicates the layer 2 protocol to be
used between the TE and MT:
PPP – Point to Point protocol for a PDP such as IP
Other values are not supported and will result in an ERROR
response to the execution Command.
Quectel