Quectel M10

M10 AT Commands Set
M10_ATC_V1.01 - 19 -
Parameter
<value> 0 Echo mode off
1 Echo mode on
Reference
V.25ter
Note
2.2.7 ATH Disconnect Existing Connection
ATH Disconnect Existing Connection
Response
Disconnect existing call by local TE from Command line and terminate call
OK
Note: OK is issued after circuit 109(DCD) is turned off, if it was previously
on.
Execution
Command
ATH[n]
Parameter
<n> 0 disconnect from line and terminate call
Reference
V.25ter
Note
2.2.8 ATI Display Product Identification Information
ATI Display Product Identification Information
Response
TA issues product information text
Example:
Quectel_Ltd
Quectel_M10
Revision: M10A01M32_SST
OK
Execution
Command
ATI
Parameter
Reference
V.25ter
Note
2.2.9 ATL Set Monitor Speaker Loudness
ATL Set Monitor Speaker Loudness
Response
OK
Execution
Command
ATL<value>
Parameter
<value> 0 low speaker volume
Quectel