Quectel M10

M10 AT Commands Set
M10_ATC_V1.01 - 111 -
<cid> a numeric parameter which specifies a particular PDP
context definition (see +CGDCONT Command)
Reference
GSM07.07
Note
5.2.7 AT+CGPADDR Show PDP Address
AT+CGPADDR Show PDP Address
Test Command
AT+CGPADDR=
?
Response
+CGPADDR: (list of defined <cid>s)
OK
Parameter
See Write Command
Write Command
AT+CGPADDR=
<cid>
Response
+CGPADDR: <cid>,<PDP_addr>
OK
ERROR
Parameters
<cid> a numeric parameter which specifies a particular PDP
context definition (see +CGDCONT Command)
<PDP_addr> a string that identifies the MT in the address space
applicable to the PDP. The address may be static or
dynamic. For a static address, it will be the one set by the
+CGDCONT Command when the context was defined. For
a dynamic address it will be the one assigned during the last
PDP context activation that used the context definition
referred to by <cid>. <PDP_ address> is omitted if none is
available.
Reference
GSM07.07
Note
This Command dictates the behavior of PPP in the ME but not that of any
other GPRS-enabled foreground layer, e.g. browser.
5.2.8 AT+CGCLASS GPRS Mobile Station Class
AT+CGCLASS GPRS Mobile Station Class
Test Command
AT+CGCLASS=
?
Response
+CGCLASS: (list of supported <class>s)
OK
Parameter
See Write Command
Read Command
AT+CGCLASS?
Response
+CGCLASS: <class>
Quectel