M10 AT Commands Set
M10_ATC_V1.01 - 138 -
7 AT Commands for TCPIP Application Toolkit
7.1 Overview
Command Description
AT+QIOPEN START UP TCP OR UDP CONNECTION
AT+QISEND SEND DATA THROUGH TCP OR UDP CONNECTION
AT+QICLOSE CLOSE TCP OR UDP CONNECTION
AT+QIDEACT DEACTIVATE GPRS PDP CONTEXT
AT+QILPORT SET LOCAL PORT
AT+QIREGAPP START TASK AND SET APN, USER NAME, PASSWORD
AT+QIACT BRING UP WIRELESS CONNECTION WITH GPRS OR CSD
AT+QILOCIP GET LOCAL IP ADDRESS
AT+QISTAT QUERY CURRENT CONNECTION STATUS
AT+QIDNSCFG CONFIGURE DOMAIN NAME SERVER
AT+QIDNSGIP QUERY THE IP ADDRESS OF GIVEN DOMAIN NAME
AT+QIDNSIP CONNECT WITH IP ADDRESS OR DOMAIN NAME
AT+QIHEAD ADD AN IP HEAD WHEN RECEIVING DATA
AT+QIAUTOS SET AUTO SENDING TIMER
AT+QIPROMPT SET PROMPT OF ‘>’ WHEN SENDING DATA
AT+QISERVER CONFIGURE AS SERVER
AT+QICSGP SET CSD OR GPRS FOR CONNECTION MODE
AT+QISRVC CHOOSE CONNECTION
AT+QISHOWRA SET WHETHER DISPLAY IP ADDRESS AND PORT OF SENDER
WHEN RECEIVE DATA
AT+QISCON SAVE TCPIP APPLICATION CONTEXT
AT+QIMODE SELECT TCPIP APPLICATION MODE
AT+QITCFG CONFIGURE TRANSPARENT TRANSFER MODE
AT+QISHOWPT Control whether to show the protocol type of the received data
AT+QIMUX Control whether to support establish multiple TCPIP connection
AT+QISHOWLA Set Whether Display local IP Address When Receive Data
AT+QIFGCNT Configure a context as foreground context
AT+QISACK Query the length of sent data and the length of acknowledged data
7.2 Detailed Descriptions of Commands
7.2.1 AT+QIOPEN Start Up TCP Or UDP Connection
AT+QIOPEN Start Up TCP Or UDP Connection
Test Command
AT+QIOPEN=?
Response
+QIOPEN: (list of supported <mode>),IP address range,(port range)
<CR><LF>+QIOPEN: (list of supported <mode>),(domain name),(port
range)
To Next Page
Loading...
Need help?
General
