Quectel M10

M10 AT Commands Set
M10_ATC_V1.01 - 154 -
<SendSz> size in bytes of data block to be received from serial port
before sending.
<esc> whether turn on the escape sequence, default is TRUE.
Reference Note
7.2.23 AT+QISHOWPT Control whether to show the protocol type of the received data
AT+QISHOWPT Control whether to show the protocol type of the received data
Test Command
AT+QISHOWP
T=?
Response
+QISHOWPT: (0-1)
OK
Read Command
AT+QISHOWP
T?
Response
+QISHOWPT: <mode>
OK
Parameters
See Write Command
Write Command
AT+QISHOWP
T=<mode>
Response
OK
ERROR
Parameters
<mode>
0 NOT show the transport protocol type at the end of header of
the received TCP/UDP data
1 Show the transport protocol type at the end of header of the
received TCP/UDP data as the following format.
+IPD(data length)(TCP/UDP):
Reference Note
This command is invalid after AT+QIHEAD=0
7.2.24 AT+QIMUX Control whether to support establish multiple TCPIP connection
AT+QIMUX Control whether to support establish multiple TCPIP connection
Test Command
AT+QIMUX=?
Response
+QIMUX: (0,1)
OK
Read Command
AT+QIMUX?
Response
+QIMUX: <mode>
OK
Parameters
See Write Command
Quectel