M10 AT Commands Set
M10_ATC_V1.01 - 126 -
Response
+QAUDCH: (0 = NORMAL_AUDIO, 1 = HEADSET_AUDIO, 2 =
LOUDSPEAKER_AUDIO, 3 = AUTO)
OK
Test Command
AT+QAUDCH=
?
Parameter
See Write Command.
Response
OK
+CME ERROR: <err>
Write Command
AT+QAUDCH=[
<n>]
Parameter
<n> 0 – Normal audio channel(default)
1 – Headset audio channel
2 – Loudspeaker audio
3 – Auto
Reference .
6.2.19 AT+QSCLK Configure Slow Clock
AT+ QSCLK Configure Slow Clock
Response
+QSCLK: <n>
OK
Read Command
AT+QSCLK?
Parameter
See Write Command.
Response
+QSCLK: (0,1)
OK
Test Command
AT+QSCLK=?
Parameter
See Write Command.
Response
OK
ERROR
Write Command
AT+QSCLK
=[<n>]
Parameter
<n> 0 – disable slow clock
1 – enable slow clock
Reference Note
6.2.20 AT+QENG Switch On Or Off Engineering Mode
AT+ QENG Switch On Or Off Engineering Mode
Read Command Response