Quectel M10

M10 AT Commands Set
M10_ATC_V1.01 - 117 -
See Write Command
Response
+QSIDET: (<gainlevel>)
OK
Test Command
AT+QSIDET=?
Parameter
See Write Command
Response
OK
ERROR
Write Command
AT+QSIDET=<
gainlevel >
Parameter
< gainlevel > int: 0 – 255
Reference Note
z <gainlevel> value is related to channel specific.
6.2.3 AT+QPOWD Power Off
AT+QPOWD Power Off
Response Write Command
AT+QPOWD =
<n>
Parameter
<n> 0 Power off urgently ( Will not send out NORMAL POWER
DOWN)
1 Normal power off (Will send out NORMAL POWER
DOWN)
Reference Note
6.2.4 AT+QTRPIN Times Remain To Input SIM PIN/PUK
AT+QTRPIN Times Remain To Input SIM PIN/PUK
Response
Times remain to input SIM PIN
+QTRPIN: <chv1>,<chv2>,<puk1>,<puk2>
OK
Execution
Command
AT+QTRPIN
Parameters
<chv1>Times remain to input chv1
<chv2>Times remain to input chv2
<puk1>Times remain to input puk1
<puk2>Times remain to input puk2
Reference Note
6.2.5 AT+QMIC Change The Microphone Gain Level
AT+QMIC Change The Microphone Gain Level
Quectel