Quectel M10 - AT+QIMODE Select TCPIP Application Mode; AT+QITCFG Configure Transparent Transfer Mode

M10 AT Commands Set
M10_ATC_V1.01 - 153 -
Reference Notice: The execution command only save the corresponding parameters
of the foreground context (refer to AT+QIFGCNT).
7.2.21 AT+QIMODE Select TCPIP Application Mode
AT+QIMODE Select TCPIP Application Mode
Test Command
AT+QIMODE=?
Response
+QIMODE:(0-NORMAL MODE,1-TRANSPARENT MODE)
OK
Read Command
AT+QIMODE?
Response
+QIMODE: <mode>
OK
Parameter
See Write Command
Write Command
AT+QIMODE=<
mode>
Response
OK
ERROR
Parameter
<mode> 0 normal mode
1 transparent mode
Reference Note
7.2.22 AT+QITCFG Configure Transparent Transfer mode
AT+QITCFG Configure Transparent Transfer Mode
Test Command
AT+QITCFG=?
Response
+QITCFG: (NmRetry:3-8),(WaitTm:2-10),(SendSz:256-1024),(esc:0,1)
OK
Read Command
AT+QITCFG?
Response
+QITCFG: <NmRetry>,<WaitTm>,<SendSz>,<esc>
OK
Parameters
See Write Command
Write Command
AT+QITCFG=<
NmRetry>,<Wai
tTm>,<SendSz>,
<esc>
Response
OK
ERROR
Parameters
<NmRetry> number of retries to be made for an IP packet.
<WaitTm> number of 100ms intervals to wait for serial input before
sending the packet.
Quectel