M10 AT Commands Set
M10_ATC_V1.01 - 143 -
?
OK
Parameters
See Write Command
Write Command
AT+QIREGAPP
=<apn>,<user
name>,<
password>[,<rat
e>]
Response
OK
ERROR
Parameters
<apn> a string parameter which indicates the GPRS access point
name or the call number of CSD
<user name> a string parameter which indicates the GPRS/CSD user name
<password> a string parameter which indicates the GPRS/CSD password
<rate> the speed of data transmit for CSD
Execution
Command
AT+QIREGAPP
Response
OK
ERROR
Reference
Note
1 The write command and execution command of this command is valid
only at the state of IP INITIAL. After operating this command, the state will
be changed to IP START.
2 the value of QICSGP (please refer to AT+QICSGP) define what kind of
bearer (GPRS or CSD) the parameters are used for.
7.2.7 AT+QIACT Bring Up Wireless Connection With GPRS Or CSD
AT+QIACT Bring Up Wireless Connection With GPRS Or CSD
Execution
Command
AT+QIACT
Response
OK
ERROR
Reference
Note
AT+QIACT only activates GPRS/CSD context at the status of IP START,
after operating this Command, the state will be changed to IP CONFIG. If
module accepts the activated operation, the state will be changed to IP IND;
after module accepting the activated operation, if activate successfully, the
state will be changed to IP GPRSACT, response OK, otherwise response
ERROR.
7.2.8 AT+QILOCIP Get Local IP Address
AT+QILOCIP Get Local IP Address
Read Command
AT+QILOCIP?
Response
OK
Execution Response