Quectel M10

M10 AT Commands Set
M10_ATC_V1.01 - 84 -
OK
Parameters
see Write Command
Response
OK
ERROR
Write Command
AT+CSSN=[<n>[
,<m>]]
Parameters
<n> a numeric parameter which indicates whether to show the
+CSSI:<code1>[,<index>] result code presentation status after a
mobile originated call setup
0 disable
1 enable
<m> a numeric parameter which indicates whether to show the
+CSSU:<code2> result code presentation status during a mobile
terminated call setup or during a call, or when a forward check
supplementary service notification is received.
0 disable
1 enable
<code1> 0 unconditional call forwarding is active
1 some of the conditional call forwarding are active
2 call has been forwarded
3 call is waiting
4 this is a CUG call (also <index> present)
5 outgoing calls are barred
6 incoming calls are barred
7 CLIR suppression rejected
<index> closed user group index
<code2> 0 this is a forwarded call
Reference Note
3.2.60 AT+CSNS Single Numbering Scheme
AT+CSNS Single Numbering Scheme
Response
+CSNS: (list of supported <mode>s)
OK
Test Command
AT+CSNS =?
Parameter
Read Command
AT+CSNS?
Response
+CSNS: <mode>
Quectel