M10 AT Commands Set
M10_ATC_V1.01 - 16 -
<value> >0
When TA returns to Command mode after call release
OK
If connection successful and voice call
OK
Parameter
<n> string of dialing digits and optionally V.25ter modifiers
dialing digits:
0-9, * , #, +, A, B, C
Following V.25ter modifiers are ignored:
,(comma), T, P, !, W, @
Emergency call:
<n> Standardized emergency number 112(no SIM needed)
<mgsm> string of GSM modifiers:
I Actives CLIR (Disables presentation of own number
to called party)
i Deactivates CLIR (Enable presentation of own
number to called party)
G Activates Closed User Group invocation for this call
only
g Deactivates Closed User Group invocation for this call
only
<;> only required to set up voice call , return to Command state
Reference
V.25ter
Note
z Parameter “I” and “i” only if no *# code is within the dial string
z <n> is default for last number that can be dialed by ATDL
z *# codes sent with ATD are treated as voice calls. Therefore, the
Command must be terminated with a semicolon “;”
z See ATX Command for setting result code and call monitoring
parameters.
Responses returned after dialing with ATD
z For voice call two different responses mode can be determined. TA
returns “OK” immediately either after dialing was completed or after
the call is established. The setting is controlled by AT+COLP. Factory
default is AT+COLP=0, this cause the TA returns “OK” immediately
after dialing was completed, otherwise TA will returns “OK”,
“BUSY”, “NO DIAL TONE”, “NO CARRIER”.
Using ATD during an active voice call:
z When a user originates a second voice call while there is already an
To Next Page
Loading...
Need help?
General
