Quectel M10

M10 AT Commands Set
M10_ATC_V1.01 - 66 -
Response
TA controls the presentation of an unsolicited result code +CREG: <stat>
when <n>=1 and there is a change in the ME network registration status.
OK
Parameters
<n>
0 disable network registration unsolicited result code
1 enable network registration unsolicited result code
+CREG: <stat>
2 enable network registration unsolicited result code with
location information
<stat> 0 not registered, ME is not currently searching a new
operator to register to
1 registered, home network
2 not registered, but ME is currently searching a new
operator to register to
3 registration denied
4 unknown
5 registered, roaming
<lac> string type; two byte location area code in hexadecimal
format
< ci > string type; two byte cell ID in hexadecimal format
Write Command
AT+CREG=<n>
Unsolicited result code
If <n>=1 and there is a change in the ME network registration status
+CREG: <stat>
If <n>=2 and there is a change in the ME network registration status or a
change of the network cell:
+CREG: <stat>[,<lac>,<ci>]
Parameters
see Write Command
Reference
GSM 07.07 [13]
Note
Quectel