Cleaning
QL-300 User Guide 375
Caution: Do not allow cloth or cotton swabs moistened with alcohol to touch the rollers
(sponge areas) on the 2nd transfer roller.
Caution: Cleaning the rollers (sponge areas) on the 2nd transfer roller is prohibited.
Touching or cleaning them could damage the surfaces of the rollers and affect print quality.
Caution: When you clean the rollers on the 2nd transfer roller, perform the 2nd transfer
roller cleaning from the menu screen on the control panel (Print Adjust > Transfer Roller
Cleaning). See “Menus” on page 145.
Caution: If the area around the 2nd transfer roller is dirty, clean it carefully without
touching the rollers.
12 If the rollers and feed surface of the feed unit on the bottom of the paper guide are dirty,
gently wipe them clean with a lint-free cloth or cotton swabs moistened with alcohol.
Caution: Do not apply force to the sensor lever.
Caution: Rotate the rollers slowly.
Note: While rotating the F4 roller with one hand, hold a lint-free cloth against the F3 roller
and F2 roller to wipe off any dirt on them.
Note: The F2 roller and the F3 roller are positioned in difficult to see locations. Use a mirror
to check the insides before you clean them. Also, use a light to brightly illuminate the
relevant areas; after checking their conditions, clean them.
To Next Page
Loading...
Need help?
General
