QL-300 User Guide 89
6
Printing
Preparing Paper
This section describes how to load paper onto the holder of the unwinder. For paper sizes and
types that can be loaded onto the unwinder, see “Paper Types, Size, and Thickness” on page
79.
1 Remove the paper from the packaging.
2 Take care of the tape that is holding the leading edge of the paper.
If there is no tape holding the leading edge of the paper, you can just load it as is.
a) Remove the tape [1] that is holding the leading edge.
Caution: Remove the tape that is holding the leading edge of the paper before you
use it. Do not load paper while the tape is still attached and feed it into the equipment.
There is a risk of damaging the equipment.
b) Cut off the part of the paper [2] on which there is leftover adhesive [3].
Caution: There is a risk of adhesive being left over after removing the tape. If paper
that still has adhesive on it is fed into the equipment, the adhesive may stick to the feed
path and damage the equipment.
3 Check the leading edge of the paper and cut it off straight.
If the leading edge of the paper is cut straight, you can just load it as is.
Be particularly careful when replacing paper and after removing and reloading jammed
paper.
When loading paper, cut the leading edge of the paper straight before loading it.
To Next Page
Loading...
Need help?
General
