Web Utility
QL-300 User Guide 434
4 Under STEP1, select Enable for IP Filtering.
Note: Enabling IP filtering disables all access from hosts that are outside the range of IP
addresses specified in STEP2.
5 Under STEP2, specify the IP address range.
• Using IP addresses, enter the range of hosts that are allowed to print and configure
settings.
• For the IP addresses, use single-byte numerals separated by periods (.).
• Entry of IP address 0.0.0.0. is invalid.
• When there is overlap of IP addresses, the address range with the highest level set in
Priority is given priority.
• Regardless of what is specified in STEP2, you can use STEP3 to specify administrator
addresses for which printing and setting configuration are enabled.
To Next Page
Loading...
