Paper Settings
QL-300 User Guide 83
f) Enter paper size information.
Input the label length and gap for media that has gaps and the black mark interval
for black mark media.
Use a ruler to measure, as accurately as possible, the actual size of the media, and
then input those values.
If the label length or the black mark interval is less than 4 inches, use the following
method to measure the media, and then input values to the first decimal place to
be accurate.
How to Measure the Actual Size of Paper
(1) Measure the length from the leading edge of the first label (or black mark
leading edge) to the leading edge of the 11th label (or black mark leading edge).
Use this as L (mm).
(2) Divide the length you measured in (1) by 10 to calculate the length from the
leading edge of the first label (or black mark leading edge) to the leading edge of
the 2nd label (or black mark leading edge) to the first decimal place.
(3) Subtract the length of the gap from the length you calculated in (2) to calculate
the length of one label to the first decimal place.
For media that has gaps, input the value calculated in (3) in Label length and input
the gap length in Gap.
For media that has black marks, input the value calculated in (2) in Black Mark
Interval.
To Next Page
Loading...
Need help?
General
