RADIOMETER ABL90 FLEX - External Barcode Reader

ABL90 FLEX reference manual 1. Setup
1-83
Step Action
1.
Use a shielded data cable with an RJ45 connector to connect the
analyzer to a network.
2. The analyzer is first connected to the computer controlling the
information system via one of the following two interfaces:
 A serial line (RS232 interface)
 An Ethernet interface (TCP/IP)
3. Once the analyzer has been physically connected to the network,
one of two of the protocols stated below is used for communication
with the central computer.
 ASTM
 HL7
 POCTDML1A
For further information, refer to the Communication protocol specifications for
Radiometer products (code no. 989-329).
Radiometer recommends that a qualified service technician carry out connection
of the analyzer to a network.
An external barcode reader can be connected and used side by side with the
built-in barcode reader – contact your Radiometer service representative.
External
barcode reader