RADIOMETER ABL90 FLEX User Manual

1. Setup ABL90 FLEX reference manual
1-20
Sample pre-registration setup
This program allows you to select interpretation of the barcode and the patient
data that can be confirmed before and during a sample measurement.
Press Menu > Utilities > Setup > Analysis setup > Sample pre-
registration to access the program.
To select the settings, do the following:
Step Action
1. Use the up/down arrow buttons to select the interpretation of the
barcode setting in the "Interpret barcode input as" box.
Choose one of the following:
 Patient ID
 Accession Number
 Sampler ID.
Note that choosing the Accession Number or Sampler ID will gray
out its check button (Sampler ID on the screen above).
2. Select the barcode entry.
3. Activate the relevant check buttons in the" Included fields" box:
Accession no., Patient first name, Patient last name, Birth date,
Patient Sex.
4. Press Close to confirm the settings and return to the main screen.

RADIOMETER ABL90 FLEX Specifications

General

Type	Blood Gas Analyzer
Analysis Time	35 seconds
Parameters Measured	pH, pCO2, pO2
Sample Volume	65 μL
Connectivity	Ethernet, USB
Calibration	Automatic
Data Management	Integrated data management system
Sample Type	Whole blood, plasma, serum
Power Requirements	100-240 V AC, 50-60 Hz, 150VA
Operating Temperature	15-32 °C (59-90 °F)
Operating Humidity	20-85% relative humidity, non-condensing