RADIOMETER ABL90 FLEX User Manual

ABL90 FLEX reference manual 1. Setup
1-53
Step Action
4. Press the check button in the "RADIANCE communication" box to
activate connection.
5. The "Connection status" box with the handshake indicates an
established connection to the RADIANCE system.
6. The Icon in the "Connection status" box indicates the state of the
RADIANCE connection. "Connected" indicates an established
connection to the RADIANCE system.
A RADIANCE icon in the Information bar will indicate the established
connection as well.
7. Clear the queue by activating the recycle bin icon. (The "Output
queue" box shows the number of data queued up for transfer. It will
be sent to the RADIANCE system.)
8. Press Close to exit.
LIS/HIS connection setup
In this program you can select the communication protocol for a connected
device.
The "Output queue" box shows the number of data queued up for transfer to
LIS/HIS. Clear, if necessary, the queue by activating the recycle bin icon.

RADIOMETER ABL90 FLEX Specifications

General

Type	Blood Gas Analyzer
Analysis Time	35 seconds
Parameters Measured	pH, pCO2, pO2
Sample Volume	65 μL
Connectivity	Ethernet, USB
Calibration	Automatic
Data Management	Integrated data management system
Sample Type	Whole blood, plasma, serum
Power Requirements	100-240 V AC, 50-60 Hz, 150VA
Operating Temperature	15-32 °C (59-90 °F)
Operating Humidity	20-85% relative humidity, non-condensing