ABL90 FLEX reference manual 1. Setup
1-67
Miscellaneous setup
In this program you can select the following options (use the arrow buttons to
display the rest of the options):
Option Function
Analyzer locked Suspends all measurements on the analyzer; other
functions such as calibrations and service programs
are still enabled.
The analyzer can be locked via this program or via a
"lock" command from an externally connected
system, e.g. LIS or RADIANCE.
Enable estimated
derived parameters
Enables estimation of the derived parameters based
on default values and parameters that have been
deselected or are not available.
Fixed pO
2
/pCO
2
decimals
If enabled, these parameters will be reported with a
fixed number of decimals.
Enable general
barcode support
Enables every text box on the Patient profile,
Patient identification, Patient result and Quality
control identification screens where it is possible
to enter a barcode.
Enable patient result
approval
Enables the additional buttons on the Patient
Result screen used for approval of results.
For detailed information, refer to chapter 4: Sample
measurement in the ABL90 FLEX operator's manual.
Apply parameter
corrections to QC
If enabled, the user-defined corrections (slope and
offset) will be applied to the QC results.
Log all measurement
activities
If enabled, "Ready", "Rinse", "Aspirating" and
"Measurement" will be registered in the Activity log.
Otherwise these activities will not be registered in
the log. This option aims to avoid too many entries
in the log.
Auto temp unit
conversion
C will be automatically changed to F if the entered
temperature is over the value of 45.
Enable screen saver The screen saver will appear if the analyzer has been
idle for 5 minutes.
Program
List of options
To Next Page
Loading...
Need help?
General
