RADIOMETER ABL90 FLEX User Manual

ABL90 FLEX reference manual 1. Setup
1-71
Analysis setup Default setting
Syringe modes S65 µL; ampoule QC. All user-defined modes are
deleted.
Capillary modes C65 µL. All user-defined modes are deleted.
Parameter profile All parameters (except FHbF) are selected.
Dynamic Parameters: Off
Sample pre-
registration
 Interpret barcode input as: Sampler ID
 Confirm pre-registered data: On
 Included fields: All fields On
Sample logistics
setup
Sample age: On (30 minutes for all parameters)
 Layouts: -R- Default
 Patient ID layout settings included in the -R-
Default layout:
- Patient ID
- Patient last name
- Patient first name
- Sample type
- Temp. °C
 Patient result settings included in the -R- Default
layout (bold text = a new title; xxx – xxx = the
reference range for a parameter):
Blood gas values
pH
xxx – xxx
pCO
2
xxx – xxx
pO
2
xxx – xxx
< New Line >
Oximetry values
ctHb
xxx – xxx
sO
2
xxx – xxx
FO
2
Hb
xxx – xxx
FCOHb
xxx – xxx
FHHb
xxx – xxx
FMetHb
xxx – xxx
FHbF
xxx – xxx
Patient reports
< New Line >
Analysis setup

RADIOMETER ABL90 FLEX Specifications

General

Type	Blood Gas Analyzer
Analysis Time	35 seconds
Parameters Measured	pH, pCO2, pO2
Sample Volume	65 μL
Connectivity	Ethernet, USB
Calibration	Automatic
Data Management	Integrated data management system
Sample Type	Whole blood, plasma, serum
Power Requirements	100-240 V AC, 50-60 Hz, 150VA
Operating Temperature	15-32 °C (59-90 °F)
Operating Humidity	20-85% relative humidity, non-condensing