R&S FSV3000 Series - Page 754

Remote Commands
R&S
®
FSVA3000/ R&S
®
FSV3000
754User Manual 1178.8520.02 ─ 01
<m> Marker
<sb> irrelevant
Parameters:
<Standard> String containing the file name. The file format is xml.
Manual operation: See " User Standards " on page 160
14.5.3.2 Configuring the Channels
The following commands configure channels for channel power and ACLR measure-
ments.
[SENSe:]POWer:ACHannel:ACPairs................................................................................754
[SENSe:]POWer:ACHannel:BWIDth:ACHannel.................................................................754
[SENSe:]POWer:ACHannel:BANDwidth:ACHannel............................................................754
[SENSe:]POWer:ACHannel:BWIDth:ALTernate<ch>..........................................................755
[SENSe:]POWer:ACHannel:BANDwidth:ALTernate<ch>.....................................................755
[SENSe:]POWer:ACHannel:BWIDth[:CHANnel<ch>]......................................................... 755
[SENSe:]POWer:ACHannel:BANDwidth[:CHANnel<ch>]....................................................755
[SENSe:]POWer:ACHannel:NAME:ACHannel...................................................................755
[SENSe:]POWer:ACHannel:NAME:ALTernate<ch>............................................................755
[SENSe:]POWer:ACHannel:NAME:CHANnel<ch>.............................................................756
[SENSe:]POWer:ACHannel:SPACing[:ACHannel]............................................................. 756
[SENSe:]POWer:ACHannel:SPACing:ALTernate<ch>........................................................ 756
[SENSe:]POWer:ACHannel:SPACing:CHANnel<ch>......................................................... 756
[SENSe:]POWer:ACHannel:TXCHannel:COUNt................................................................757
[SENSe:]POWer:ACHannel:ACPairs <ChannelPairs>
This command defines the number of pairs of adjacent and alternate channels.
Parameters:
<ChannelPairs> Range: 0 to 12
*RST: 1
Manual operation: See " Number of channels: Tx , Adj " on page 160
See " Number of Adjacent Channels ( Adj Count )" on page 176
[SENSe:]POWer:ACHannel:BWIDth:ACHannel <Bandwidth>
[SENSe:]POWer:ACHannel:BANDwidth:ACHannel <Bandwidth>
This command defines the channel bandwidth of the adjacent channels.
Parameters:
<Bandwidth> Range: 100 Hz to 1000 MHz
*RST: 14 kHz
Default unit: Hz
Manual operation: See " Channel Bandwidth " on page 164
See " Adjacent Channel Bandwidths " on page 177
Configuring and Performing Measurements