Renesas PG-FP6 V1.06

PG-FP6 V1.06 4. Usage of the FP6 Terminal
R20UT4469EJ0800 Rev.8.00 Page 46 of 188
Oct.01.21
(G) Reset Vector
Enter the reset vector value of the target device in hexadecimal notation.
(H) Security Code
Set the ID code or the access password.
• “Set Option”
 “Do Nothing”: An ID code or access password is not set.
 “Set”: The setting of an ID code or access password is enabled.
• ID Code
Enter the ID code in hexadecimal notation.
• Code Flash Access Password
Enter the password for accessing code flash memory in hexadecimal notation.
• Data Flash Access Password
Enter the password for accessing data flash memory in hexadecimal notation.
(I) Boot Area
Specify the end block of the boot area.
(J) Connection Prohibited
Make the setting for disabling connection in serial programming mode or both the debugger and serial
programming mode.
• “Disable Serial Programming”
 “Do Nothing”: Serial programming is not disabled.
 “Set”: Connection in serial programming mode is disabled.
• “Disable Debugger and Serial Programming”
 “Do Nothing”: Debugger and serial programming are not disabled.
 “Set”: Connection in debugger and serial programming mode is disabled.
Caution: Once the Connection Prohibited function is set for an MCU, the setting cannot be reversed.
(K) DLM
Make the setting for DLM state transitions. Use this setting when DLM state transitions are set in
response to other processing such as the programming of a program file. When a DLM state transition
requires authentication, use the DLM transition in the menu for the target device.
• “Set Option”
 “Do Nothing”: A transition of the DLM state is not to be set.
 “Set”: The setting of DLM transitions is enabled.
• “Target State”
Select the destination of the DLM transition from the pull-down menu.
(L) DLM Keys
Specify the DLM key file for use in DLM authentication which is to be set for the target device.
For details on how to generate DLM keys, refer to chapter 9, Renesas Flash Programmer Utility Program.
• “Set Option”
 “Do Nothing”: A DLM key is not to be set.
 “Set”: The setting of a DLM key is enabled.