Renesas PG-FP6 V1.06

PG-FP6 V1.06 4. Usage of the FP6 Terminal
R20UT4469EJ0800 Rev.8.00 Page 51 of 188
Oct.01.21
Cautions:
- When an RX-family device is connected via the FP6, input the value in the order (control code)
ID1, ID2, ..., ID16.
Example:
When the number of effective bytes = 16, control code = 0x45, ID code = ID1=0x01, ID2=0x02,
ID3=0x03, ID4=0x04, ID5=0x05, ID6=0x06, ID7=0x07, ID8=0x08, ID9=0x09, ID10=0x0A,
ID11=0x0B, ID12=0x0C, ID13=0x0D, ID14=0x0E and ID15=0x0F, the value will be
‘450102030405060708090A0B0C0D0E0F’.
- When RX72x, RX71x, RX66x, RX65x, or RX64x device is connected via a debug tool which has
been specified with the CS+ or e2 studio, the order for input of the authentication code changes to
that shown below.
ID4 ID3 ID2 ID1 ID8 ID7 ID6 ID5 ID12 ID11 ID10 ID9 ID16 ID15 ID14 ID13
- FP6 repeats it up to three times if ID code authentication fails.
- When an RA-family, Renesas Synergy-family, or RE-family device is connected to the FP6, input
values to be specified for registers of the target device in order of bits 127 to 0 in byte units. Since
the input specification may also differ with the tool, confirm the input specification of the tool you
will be using.
- For an RH850-family device, when the ID code for programming is to be generated in a program
file instead of on the [Option Settings] tabbed page, enter the value set for the register in the target
device from the higher-order bits in byte units. Example: For ID255 to ID0, the first byte is entered
as ID255 to ID248 and the second byte is entered as ID247 to ID240.
Remark: The default authentication code in some target devices at the time of shipment is all FFs. For
details, refer to the user’s manual of the target device.
(E) RH850 SVR Settings
Make the settings for the SVR parameters when the PG-FP6 is connected to the target device.
“Override SVR parameters”
 “Using program files”: The parameters from the program file are used.
 “Disable SVR”: The SVR function is disabled.