Message Problem and solutions
Established SPX Connection with PServer,
(RPSocket=<socket number>,
connID=<connection ID>)
Connection to the print server was established
when the remote printer went online.
exiting The lpd service has ended and the system is exiting
the process.
Exit pserver The print server function was disabled because the
necessary print server settings have not been made.
Frametype=<frame type name> The specified frame type name <frame type name>
is for NetWare use.
IEEE 802.11 Card does NOT support WPA . A wireless card that does not support WPA is
installed. Install a wireless card that supports WPA.
IEEE 802.11 Card Firmware REV.<version> Displays the version number of the 802.11 card's
firmware.
IEEE 802.11 current channel <channel number> Displays the current channel number of the active
wireless card (in ad hoc and infrastructure mode).
IEEE 802.11 MAC Address = <MAC address> Displays the MAC address of the wireless interface.
IEEE 802.11 SSID <ssid> (AP MAC Address
<MAC address>)
The MAC address and SSID of the access point are
connected in infrastructure mode.
IEEE 802.11 <communication mode> mode Displays IEEE 802.11 communication mode.
(IKE phase-1) mismatched authentication type:
local=<authentication type 1>
remote=<authentication type 2>
This machine's <authentication type> in IKE phase
1 does not match the communicating host's
<authentication type 1>, Make sure this machine's
<authentication type 2> matches that of the
communicating host.
(IKE phase-1) mismatched encryption type:
<encryption algorithm 1> remote=<encryption
algorithm 2>
This machine's ISAKMP SA Oakley group
<encryption algorithm 1> in IKE phase 1 does not
match the communicating host's ISAKMP SA
Oakley group < encryption algorithm 2>, Make
sure this machine's ISAKMP SA Oakley group
matches that of the communicating host.
(IKE phase-1) mismatched DH group: local=<DH
group number 1> remote=<DH group number 2>
This machine's ISAKMP SA Oakley group <DH
group number 1> in IKE phase 1 does not match
the communicating host's ISAKMP SA Oakley
4. Monitoring and Configuring the Printer
232
To Next Page
Loading...
Need help?
General
