Message Problem and solutions
group <DH group number 2>, Make sure this
machine's ISAKMP SA Oakley group matches that
of the communicating host.
(IKE phase-1) mismatched hash type: local=<Hash
Algorithm 1> remote=<Hash Algorithm 2>
This machine's ISAKMP SA <Hash Algorithm 1> in
IKE phase 1 does not match the communicating
host's ISAKMP SA <Hash Algorithm 2>, Make sure
this machine's ISAKMP SA Hash Algorithm matches
that of the communicating host.
Interface (interface name): Duplicate IP Address
(<IP address>).
The same IP (IPv4 or IPv6) address was used. Each
IP address must be unique. Check the address of
the device indicated in [IP address].
<Interface name> card removed The interface managed by the supplicant has been
removed.
<Interface name> interface down The interface managed by the supplicant is
disabled, or cannot connect to the access point.
<Interface name> interface up The interface managed by the supplicant is
enabled, or is connected to the access point.
< Interface > started with IP: < IP address > IP address (IPv4 or IPv6 address) has been set for
the interface and is operating.
< Interface >: Subnet overlap. The same IP address (IPv4, orIPv6 address) and the
subnet mask is used with other device.
job canceled. jobid=%d. The spooled job was canceled due to error or user
request.
LEAP challenge to access point failed The LEAP challenge to the access point has failed.
Login to fileserver <file server name> (<IPX|IP>),
<NDS|BINDERY>
When the print server was online, the system
logged in to <file server> in NDS or BINDERY
mode. The transfer protocol in use is also displayed.
Memory allocate error. Date cannot be obtained. Disconnect the USB
cable, and then connect it.
MIC failure TKIP counter measures started The supplicant using TKIP has detected two
instances of tampering within 60 seconds and has
started counter measures.
Message List
233
To Next Page
Loading...
Need help?
General
